Brake Job Gm Acadia Buick Outlook Enclave-PDF Free Download

BRAKE JOB GM Acadia Buick Outlook Enclave
18 Feb 2020 | 30 views | 0 downloads | 5 Pages | 358.56 KB

Share Pdf : Brake Job Gm Acadia Buick Outlook Enclave

Download and Preview : Brake Job Gm Acadia Buick Outlook Enclave

Report CopyRight/DMCA Form For : Brake Job Gm Acadia Buick Outlook Enclave



Transcription

Printer Friendly Page 2 of 5, with anti rattle clips To release the pad from the clip there are tabs at the ends of pad. that are depressed to release the pad The pads have noise dampening material attached. to the back of the pads, Front Pad Install, Inspect the dust boots for damage and replace if necessary Inspect the guide pins and. replace and lubricate if necessary The boot is, to be seated in the grooves of the caliper. bracket and guide pin, Install new anti rattle clips and pads rotate. the caliper and align the flats on the guide pin, to the mounting ear of the caliper Torque the.
guide pin bolts to 64 Nm 30 ft lbs, The caliper bracket bolts on this vehicle use. high strength thread locker to hold it in place, it is the red stuff Make sure to clean the. old thread locker material off the threads with, denatured alcohol before putting new thread. locker on The bolts should be tightened to a, whopping 129 ft lbs. Inspect the dust boots for damage and replace, the caliper if necessary Inspect the guide.
pins and replace and lubricate if necessary, The boot is to be seated in the grooves of the caliper bracket and guide pin Install new. anti rattle clips and pads rotate, the caliper and align the flats on. the guide pin to the mounting ear, of the caliper Torque the guide. pin bolts to 64 Nm 30 ft lbs, Like in the front the rear caliper. brackets use thread locker Make, sure to clean threads Then torque.
the bolts to 148 ft lbs, Rotor and Hub Inspection, Specifications. Front Brakes, http www brakeandfrontend com www Controls PrinterFriendly PrinterFriendly aspx 10 23 2009. Printer Friendly Page 3 of 5, Max allowable assembled lateral runout 0 06 mm 0 002. Max allowable scoring 1 50 mm 0 059, Max allowable thickness variation 0 025 mm 0 001. Rear Brakes, Min thickness 18 4 mm 0 72, New thickness 20 mm 0 79.
Max allowable assembled lateral runout 0 06 mm 0 002. Maximum allowable scoring 1 50 mm 0 059, Max allowable thickness variation 0 025 mm 0 001. Rotor Lateral Runout, Inspection Procedure, The hub and rotor are matched. with the rotor indexed to the hub, and secured with a Torx setscrew. Three lugs should be used to, ensure the rotor is secured to the. hub Attach the dial indicator to, the steering knuckle and position.
the indicator at 90 to the rotor, surface approximately 12 7 mm. 0 50 from the rotor Replace, any rotor that is worn or. machined below this, specification, If the rotor is within runout specification new pads and anti rattle clips can be installed. If the rotor is out of specification for lateral runout a shim between the hub and rotor. can correct the runout, Shim Installation Procedure. GM has approved the shims from Brake Align for, the correction of the runout for rotors machined on.
both on and off vehicle lathes Mark the high, spot on the rotor and the stud closest to the high. spot To check the bearing hub remove the, caliper bracket and rotor. Remove the caliper bracket It is secured to the, knuckle with 19 mm bolts with thread lock. adhesive When replacing the bracket clean the, bolt and apply thread lock adhesive to the center. section of the threads Torque the front caliper, bracket mounting bolts to 175 Nm 129 ft lbs.
The torque the rear to caliper bracket mounting, bolts to 200 Nm 148 ft lbs Remove the Torx. retaining screw and rotor The hub is checked at, the outer machined surface with the indicator at. 90 to the rotor s surface, Mark the hub for run out and the stud closest to the high spot The machined surfaces of. the hub and rotor should be cleaned before the shim is installed with the V notch aligned. http www brakeandfrontend com www Controls PrinterFriendly PrinterFriendly aspx 10 23 2009. Printer Friendly Page 4 of 5, with high spot on the vehicle hub Reinstall the rotor and torque the retaining screw to. 12 Nm 106 in lbs, Parking Brake, The parking brake is located in the hat section of the rear rotor It is applied.
mechanically by a cable actuated cam and lever located in the bottom of the backing. plate The shoes are attached to the backing plate with a pin and leaf spring The shoes. are held against the cam and lever with a spring, A spring is also used to hold the shoes against the adjusting screw The shoes are. adjusted by rotating the star wheel on an adjusting screw located at the top of the. backing plate There is an, adjusting slot located in the hat. section of the rotor It will, require an old fashioned adjusting. spoon to reach the star wheel, The method of adjustment is to. turn the rotor and adjust the star, wheel until the shoes drag on the.
drum Then back off the adjusting, star until the rotor turns free The. rotor should be secured with the, retaining screw and three lug nuts. when the parking brake shoes are, Like most modern brake systems. with ABS the system has an, automated bleed procedure that. requires a scan tool An automated bleed is required if a hydraulic component like the. modulator unit is replaced Even if you are performing a gravity pressure or manual. bleed it is a good idea to run an automated bleed procedure as a way to ensure the there. is not any air trapped in the brake modulator or proportioning valve assembly. The bleeding sequence is left front left rear right front and right rear If pressure. bleeding GM recommends between 25 30 psi, Service Hints.
What if the booster does not feel right, If the brake booster activates excessively or if excessive effort of the brake pedal is. consistently required Hydraulic Brake Booster HBB calibration may be needed To. do this it will require a scan tool with the right software The procedure is simple and. requires pressing the brake and gas in the right sequence. What if the brake pedal squeaks on application, TSB 08 05 22 002B is one of the most curious on record for a manufacturer The. bulletin covers all of the the Acadia and a lot of GM vehicles from 2004 2008. The bulletin states Some customers may comment on a squeak noise when the brake. pedal is applied or when released This noise is normally heard when the brake pedal is. slowly applied with the engine on or off but can occur when the brake pedal is released. The noise may be isolated to the master cylinder area. To correct the problem GM advises removing as much of the old brake fluid from the. http www brakeandfrontend com www Controls PrinterFriendly PrinterFriendly aspx 10 23 2009. Printer Friendly Page 5 of 5, master cylinder as possible and refill with new DOT 3 brake fluid Start the vehicle and. fully cycle the brake pedal until the noise diminishes to allow the new fluid to enter the. system Was it a bad batch of brake fluid GM has been silent on the cause. What if the customer complains of ABS noise during first driving Enclave. Acadia and Outlook 2007 2008 Model Years, Some customers may comment on excessive ABS initialization noise which may be. mistaken as front suspension noise In addition customers of 2008 model year vehicles. may comment on traction control sensitivity The ABS unit runs diagnostic routines as. soon as the vehicle reaches 15 km h 9 mph Some customers may find the valve noise. objectionable, The cure is to re flash the module so the self test is less noticeable Prior to.
programming you will need to know the tire size Calibrations for 2008 model year. vehicles contain additional software to reduce the traction control sensitivity. Brake and Front End Copyright 2009 Brake and Front End All Rights Reserved. http www brakeandfrontend com www Controls PrinterFriendly PrinterFriendly aspx 10 23 2009. BRAKE JOB GM Acadia Buick Outlook Enclave The Lambda Platform is shared with the Chevrolet Traverse Saturn Outlook GMC Acadia and Buick Enclave It is largely derived from the GM Epsilon platform the same platform that makes the Chevrolet Malibu and Pontiac G6 These vehicles can be front or all wheel drive All models have the same

Related Books

C Acadia Acadia Denali M Y CM MY CY CMY Acadia Acadia

C Acadia Acadia Denali M Y CM MY CY CMY Acadia Acadia

Mexico 9803770 2017 crc 3 8 16 2 Introduction Introduction The names logos emblems slogans vehicle model names and vehicle body designs appearing in this manual including but not limited to GM the GM logo GMC the GMC Truck Emblem ACADIA and DENALI are trademarks and or service marks of General Motors LLC its subsidiaries affiliates or licensors For vehicles first sold in

Acadia Acadia Denali Enclave Traverse Lucerne Buick

Acadia Acadia Denali Enclave Traverse Lucerne Buick

Acadia Acadia Denali Enclave Traverse Lucerne Navigation System 2011 Black plate 4 1 4 Infotainment System This manual describes features that may or may not be on your specific vehicle either because they are options that you did not purchase or due to changes subsequent to the printing of this owner manual Please refer to the purchase

Get To Know Guide Acadia 2009 B Acadia 2009 B

Get To Know Guide Acadia 2009 B Acadia 2009 B

Congratulations on your purchase of a GMC Acadia Please read this information and your Owner Manual to ensure an outstanding ownership experience Note that your vehicle may not include all the features described in this booklet Keep this booklet with your Owner Manual for easy reference DRIVER INFORMATION Instrument Panel

2012 GMC Acadia Acadia Denali Owner Manual M

2012 GMC Acadia Acadia Denali Owner Manual M

GMC Acadia Acadia Denali Owner Manual 2012 Black plate 4 1 iv Introduction Using this Manual To quickly locate information about the vehicle use the Index in the back of the manual It is an alphabetical list of what is in the manual and the page number where it can be found Danger Warnings and Cautions Warning messages found on vehicle

3 13 Acadia Acadia Denali Enclave Traverse Infotainment

3 13 Acadia Acadia Denali Enclave Traverse Infotainment

Acadia Acadia Denali Enclave Traverse Infotainment System 2013 CRC 1 Black plate 10 1 3 13 10 Infotainment System Home Page Features Some features are disabled when the vehicle is moving and some icons may not be active Touch screen buttons are highlighted in color when available or greyed out when not available

C M Y MY CY CMY Acadia Acadia Denali K Owner s Manual

C M Y MY CY CMY Acadia Acadia Denali K Owner s Manual

GMC Acadia Acadia Denali Owner Manual GMNA Localizing U S Canada Mexico 12146149 2019 crc 3 27 18 Introduction 3 Danger Danger indicates a hazard with a high level of risk which will result in serious injury or death Warning Warning indicates a hazard that could result in injury or death Caution Caution indicates a hazard that

2011 GMC Acadia Acadia Denali Owner Manual M

2011 GMC Acadia Acadia Denali Owner Manual M

GMC Acadia Acadia Denali Owner Manual 2011 Black plate 4 1 iv Introduction Using this Manual To quickly locate information about the vehicle use the Index in the back of the manual It is an alphabetical list of what is in the manual and the page number where it can be found Danger Warnings and Cautions Warning messages found on vehicle

Mexico 9159268 2016 CRC 4 16 15 GMC Acadia Acadia

Mexico 9159268 2016 CRC 4 16 15 GMC Acadia Acadia

GMC Acadia Acadia Denali Owner Manual GMNA Localizing U S Canada Mexico 9159268 2016 CRC 4 16 15 2 Introduction Introduction The names logos emblems slogans vehicle model names and vehicle body designs appearing in this manual including but not limited to GM the GM logo GMC the GMC Truck Emblem ACADIA and DENALI are

2014 GMC Acadia Acadia Denali Owner Manual M

2014 GMC Acadia Acadia Denali Owner Manual M

GMC Acadia Acadia Denali Owner Manual GMNA Localizing U S Canada Black plate 3 1 Mexico 6014315 2014 crc 8 15 13 Introduction iii The names logos emblems slogans vehicle model names and vehicle body designs appearing in this manual including but not limited to GM the GM logo GMC the GMC Truck Emblem ACADIA and

GMC Acadia Acadia Denali Owner Manual 2011 Black plate

GMC Acadia Acadia Denali Owner Manual 2011 Black plate

GMC Acadia Acadia Denali Owner Manual 2011 Black plate 4 1 iv Introduction Using this Manual To quickly locate information about the vehicle use the Index in the back of the manual It is an alphabetical list of what is in the manual and the page number where it can be found Danger Warnings and Cautions Warning messages found on vehicle

2013 Acadia Acadia Denali Owner Manual M GMC

2013 Acadia Acadia Denali Owner Manual M GMC

Acadia Acadia Denali Owner Manual 2013 crc2 12 11 12 Black plate 3 1 Introduction iii The names logos emblems slogans vehicle model names and vehicle body designs appearing in this manual including but not limited to GM the GM logo GMC the GMC Truck Emblem ACADIA and DENALI are trademarks and or service marks of General Motors

Mex 2012 Acadia Acadia Denali Enclave and Traverse

Mex 2012 Acadia Acadia Denali Enclave and Traverse

Acadia Acadia Denali Enclave and Traverse Navigation System Includes Black plate 10 1 Mex 2012 10 Infotainment System 9 Once a city has been selected the Street name category is automatically selected for entry Do not enter directional information or street type Use the space symbol screen button Ubetween street or city names Use