EN 301 908-14 - V13.1.1 - IMT Cellular Networks .

ETSI EN 301 908-14 V13.1.1 (2019-09)HARMONISED EUROPEAN STANDARDIMT cellular networks;Harmonised Standard for access to radio spectrum;Part 14: Evolved Universal Terrestrial Radio Access (E-UTRA)Base Stations (BS)

2ETSI EN 301 908-14 V13.1.1 (2019-09)ReferenceREN/MSG-TFES-13-14Keywords3G, 3GPP, cellular, digital, E-UTRA, IMT,IMT-2000, LTE, mobile, radio, regulation, UMTSETSI650 Route des LuciolesF-06921 Sophia Antipolis Cedex - FRANCETel.: 33 4 92 94 42 00 Fax: 33 4 93 65 47 16Siret N 348 623 562 00017 - NAF 742 CAssociation à but non lucratif enregistrée à laSous-Préfecture de Grasse (06) N 7803/88Important noticeThe present document can be downloaded from:http://www.etsi.org/standards-searchThe present document may be made available in electronic versions and/or in print. The content of any electronic and/orprint versions of the present document shall not be modified without the prior written authorization of ETSI. In case of anyexisting or perceived difference in contents between such versions and/or in print, the prevailing version of an ETSIdeliverable is the one made publicly available in PDF format at www.etsi.org/deliver.Users of the present document should be aware that the document may be subject to revision or change of status.Information on the current status of this and other ETSI documents is available .aspxIf you find errors in the present document, please send your comment to one of the following pportStaff.aspxCopyright NotificationNo part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopyingand microfilm except as authorized by written permission of ETSI.The content of the PDF version shall not be modified without the written authorization of ETSI.The copyright and the foregoing restriction extend to reproduction in all media. ETSI 2019.All rights reserved.DECT , PLUGTESTS , UMTS and the ETSI logo are trademarks of ETSI registered for the benefit of its Members.3GPP and LTE are trademarks of ETSI registered for the benefit of its Members andof the 3GPP Organizational Partners.oneM2M logo is a trademark of ETSI registered for the benefit of its Members andof the oneM2M Partners.GSM and the GSM logo are trademarks registered and owned by the GSM Association.ETSI

3ETSI EN 301 908-14 V13.1.1 (2019-09)ContentsIntellectual Property Rights .7Foreword.7Modal verbs terminology.8Introduction .81Scope .92References .102.12.233.13.23.34Normative references . 10Informative references . 11Definition of terms, symbols and abbreviations .12Terms. 12Symbols . 18Abbreviations . 20Technical requirements specifications .214.1Environmental profile. 214.2Conformance requirements . 214.2.1Introduction. 214.2.2Operating band unwanted emissions . 284.2.2.1Definition . 284.2.2.2Limits . 284.2.2.2.0General . 284.2.2.2.1Limits for Wide Area BS (bands 1, 3, 8, 32, 33, 34 or 65) . 304.2.2.2.2Limits for Wide Area BS (bands 7, 22, 38, 40, 42, 43 and 69) . 314.2.2.2.3Limits for Wide Area BS (bands 20, 28, 31, 67 and 68) . 344.2.2.2.4Limits for Local Area BS . 354.2.2.2.5Limits for Home BS . 364.2.2.2.6Additional limits for protection of DTT . 384.2.2.2.7Limits for protection of adjacent band services . 384.2.2.2.8Limits for Medium Range BS . 384.2.2.2.9Additional limits for operation in band 32 . 434.2.2.2.10Minimum requirements for Local Area and Medium Range BS in band 46 . 434.2.2.2.11Minimum requirements for stand-alone NB-IoT Wide Area BS . 444.2.2.3Conformance . 444.2.3Adjacent Channel Leakage Power Ratio (ACLR) . 444.2.3.1Definition . 444.2.3.2Void. 454.2.3.3Void. 454.2.3.4Limits . 454.2.3.4.1ACLR Limits . 454.2.3.4.2Cumulative ACLR test requirement in non-contiguous spectrum limits . 474.2.3.5Conformance . 494.2.4Transmitter spurious emissions. 494.2.4.1Definition . 494.2.4.2Limits . 504.2.4.2.1Spurious emissions . 504.2.4.2.2Co-existence with other systems . 504.2.4.2.3Protection of the BS receiver of own or different BS . 524.2.4.2.4Co-existence with Home BS operating in other bands . 524.2.4.3Conformance . 534.2.5Base Station maximum output power . 544.2.5.1Definition . 544.2.5.2Limit . 544.2.5.3Conformance . 544.2.6Transmitter intermodulation . 544.2.6.1Definition . 54ETSI

5.3.2.35.3.3ETSI EN 301 908-14 V13.1.1 (2019-09)Limit . 55Conformance . 55Receiver spurious emissions . 56Definition . 56Limit . 56Conformance . 56Blocking characteristics . 57Definition . 57Limit . 57Conformance . 62Receiver intermodulation characteristics . 63Definition . 63Limit . 63Conformance . 69Adjacent Channel Selectivity (ACS) and narrow-band blocking . 70Definition . 70Limit . 70Conformance . 76Home BS output power for adjacent UTRA channel protection. 76Definition . 76Limit . 76Conformance . 77Home BS output power for adjacent E-UTRA channel protection . 77Definition and applicability. 77Limit . 77Conformance . 78Home BS output power for co-channel E-UTRA protection . 78Definition and applicability. 78Limit . 78Conformance . 79Reference sensitivity level . 79Definition . 79Limits . 79Conformance . 81Downlink channel access procedure (Listen before talk - LBT). 81General . 81Limits . 82Conformance . 82Dynamic Frequency Selection (DFS) . 82General . 82Limits . 82Conformance . 82Base Station output power (band 46) . 82General . 82Limits . 82Conformance . 82Testing for compliance with technical requirements.83Environmental conditions for testing . 83Interpretation of the measurement results . 83Essential radio test suites . 83Introduction. 83Operating band unwanted emissions . 84General . 84Initial conditions . 84Procedure . 84Test requirement . 85Adjacent Channel Leakage power Ratio (ACLR) . 85Initial conditions . 85Procedure . 86Test requirement . 86Transmitter spurious emissions. 87ETSI

5.3.155.3.16ETSI EN 301 908-14 V13.1.1 (2019-09)General . 87Initial conditions . 87Procedure . 87Test requirements . 88Base Station maximum output power . 88General . 88Initial conditions . 88Procedure . 89Test requirement . 89Transmitter intermodulation . 89General . 89Initial conditions . 89Procedures . 90Test requirement . 91Receiver spurious emissions . 91General . 91Initial conditions . 91Procedure . 92Test requirement . 92Blocking characteristics . 92General . 92Initial conditions . 92Procedure . 93Test requirement . 95Receiver intermodulation characteristics . 95General . 95Initial conditions . 95Procedures . 95Test requirement . 97Adjacent Channel Selectivity (ACS) and narrow-band blocking . 97General . 97Initial conditions . 97Procedure for Adjacent Channel Selectivity . 97Procedure for narrow-band blocking. 98Test requirement . 100Home BS output power for adjacent UTRA channel protection. 100Initial conditions . 100Procedure . 100Test requirement . 101Home BS output power for adjacent E-UTRA channel protection . 101Initial conditions . 101Procedure . 101Test requirement . 102Home BS output power for co-channel E-UTRA protection . 102Initial conditions . 102Procedure . 102Test requirement . 103Reference sensitivity level . 103General . 103Initial conditions . 103Procedure . 103Test requirement . 104Downlink channel access procedure . 104General . 104Initial conditions . 104Procedure . 104Test requirements . 105Dynamic frequency selection (DFS) . 105Base Station output power (band 46) . 105Annex A (informative):Relationship between the present document and the essentialrequirements of Directive 2014/53/EU .106ETSI

6Annex B (normative):ETSI EN 301 908-14 V13.1.1 (2019-09)Base Station configurations.108B.1Reception with multiple receive

ETSI EN 301 908-14 V13.1.1 (2019-09) IMT cellular networks; Harmonised Standard for access to radio spectrum; Par