#07-08-52-001B: Remote Keyless Entry (RKE) Inoperative .
Document ID: 1990156Page 1 of 52007 Chevrolet Impala Impala, Monte Carlo (VIN W) Service Manual View All Bulletins Document ID: 1990156#07-08-52-001B: Remote Keyless Entry (RKE)Inoperative, Poor Range, Tire Pressure Monitor (TPM)Message Displayed, Remote Vehicle Start (RVS)(Replace/Reprogram RCDLR, Replace Antenna andTransmitters) - (Jun 19, 2007)Subject:Remote Keyless Entry (RKE) Inoperative, Poor Range, TirePressure Monitor (TPM) Message Displayed, Remote VehicleStart (RVS) (Replace/Reprogram RCDLR, Replace Antenna andTransmitters)Models:2006-2007 Buick Lucerne2006-2007 Cadillac DTS2006-2007 Chevrolet Impala, Monte CarloThis bulletin is being revised to include an "Important" statement containing breakpointinformation based on the vehicle's build date. Please discard Corporate Bulletin Number07-08-52-001A (Section 08 - Body and Accessories).ConditionImportant: This bulletin does not apply to vehicles built after the following dates: DTS / Lucerne: 5/1/07 Impala / Monte Carle: 3/1/07For vehicles built after these dates, refer to SI for diagnosis and repair information.Some customers may comment about one or more of the following conditions: The remote keyless entry (RKE) transmitters will not program, function and/or the RKEtransmitter low battery message is displayed. The Service Tire Monitor System message is displayed. The new RKE transmitter cannot be programmed. The remote keyless entry (RKE) and/or remote vehicle start (RVS) transmitter has poorrange.CauseAny of these concerns may be caused by an internal fault with the transmitters and/or the RemoteControl Door Lock Receiver (RCDLR) software/hardware. 2008 General Motors Corporation. All rights key 1990156&from bcpi10/24/2008
Document ID: 1990156Page 2 of 5CorrectionImportant: This bulletin does not apply to vehicles built after the following dates: DTS / Lucerne: 5/1/07 Impala / Monte Carle: 3/1/07For vehicles built after these dates, refer to SI for diagnosis and repair information.DO NOT REPLACE THE BCM.Important: The 2006 and 2007 Impala LS without AP8 does not have a coax antenna. The 2006 and 2007 Lucerne without AP3 or AP8 does not have a coax antenna.1. Replace the RCDLR module and the RCDLR antenna using the following procedure:Impala / Monte Carlo1.1. Remove the driver's side "A" pillar molding and I/P closeout panel.1.2. Unplug the speaker.1.3. To expose the RCDLR antenna, partially remove the driver's side upper I/P closeoutpanel (near windshield).1.4. Remove the clips holding the RCDLR antenna wire at the RCDLR module and along the"A" pillar.1.5. Cut the old RCDLR antenna wire a minimum of 152 mm (6 in) from the button(connecting to the windshield), leaving that portion of the old RCDLR antennaconnected to the windshield.1.6. Remove the I/P carrier bolt and remove the old RCDLR antenna.1.7. Remove the RCDLR module.1.8. Install the new RCDLR module.1.9. Lay in the new RCDLR antenna and reinstall the carrier bolt.1.10. Connect the new antenna to the RCDLR antenna module.1.11. Clip the new RCDLR antenna into place using the existing holes on the "A" pillar.1.12. Reinstall the I/P close-out panel.1.13. Reconnect the speaker wire.Important: Be sure that the end of the old RCDLR antenna is tucked behind the "A"pillar molding. The button on the windshield is no longer functional, however leavingthe cover on the button will provide a cleaner look to the vehicle.1.14. Reinstall the "A" pillar molding and I/P side closeout panel.DTS1.1. Remove the rear seat cushion.1.2. Remove the rear seat back.http://gsi.xw.gm.com/si/showDoc.do?docSyskey 1990156&from bcpi10/24/2008
Document ID: 1990156Page 3 of 51.3. Lower and remove the trunk trim cover to gain access to the underside of the rearpackage shelf.1.4. Remove the rear seat belts.1.5. Remove the interior C-pillar trim (sail) panels and package shelf.1.6. Remove the RCDLR module and antenna.TipThe existing antenna is grounded into another wiring harness. It will be necessary to pull theexisting harness and antenna up near the C-pillar in order to disconnect the antenna fromthe other wiring harness.Important: The new antenna will not be grounded into the other wiring harness.1.7. Install a new RCDLR module and antenna.1.8. Tape back the harness ground connection.1.9. Reinstall the rear package shelf.1.10. Reinstall the interior C-pillar trim (sail) panels.1.11. Reinstall the rear seat belts.1.12. Reinstall the trunk trim cover.1.13. Reinstall the rear seat back.1.14. Reinstall the rear seat cushion.Lucerne1.1. Remove left rear C-pillar trim (sail) panel.1.2. Remove the RCDLR antenna and receiver/module (located under the shelf package -accessed through the trunk).TipThe existing antenna is grounded into another wiring harness. It will be necessary to pull theexisting harness and antenna up near the C-pillar in order to disconnect the antenna fromthe other wiring harness.Important: The new antenna will not be grounded into the other wiring harness.1.3. Reinstall the new antenna and RCDLR receiver/module.1.4. Reinstall the C-pillar trim (sail) panel.Important: When programming a new or existing RCDLR, the programming instructions inSI must be followed.2. Reprogram the RCDLR with the latest software update available through TIS2WEB.Important: On vehicles equipped with Tire Pressure Monitoring (TPM), the tire type and tirepressures must be selected in the module set-up using the Tech 2 . If this step is notperformed, the RCDLR will not retain the tire pressures after the TPM system is ey 1990156&from bcpi10/24/2008
Document ID: 1990156Page 4 of 5Tip: When selecting the Tire Type/Pressure, choose the appropriate selection on theTech 2 based on psi, not kPa. The vehicle must be driven immediately. Monitor thetire pressures on the DIC and drive the vehicle until dashes no longer appear. After the learn procedure is complete, be sure to set the tire pressures according to theinformation on the tire placard.3. If equipped with Tire Pressure Monitoring System, perform the Tire Pressure Sensor Relearnusing the J 46079 following the procedure found in SI.4. Replace both Remote Keyless Entry transmitters. New transmitters are identified by a star onthe back of the transmitter. It is important to verify that the replacement transmitters have astar on the back.5. Program the transmitters using the procedure listed in SI.Parts InformationImportant: Refer to the parts catalog using the VIN of the vehicle being serviced to identify thecorrect part numbers.Impala / Monte CarloPart NumberDescription25837954Antenna -- Remote Control Door Lock Receiver (Impala Only)25845987Antenna -- Remote Control Door Lock Receiver (Monte Carlo Only)15912859Transmitter -- 4 Button with Trunk15912860Transmitter -- with Remote Vehicle Start System25808836Receiver -- Remote Control Door Lock ( with RKE and without RVSS)25808837Receiver -- Remote Control Door Lock ( with RKE and RVSS)DTSPartNumberDescription15912860Transmitter -- with Remote Vehicle Start System15913507Transmitter - JAPAN ONLY -- with Remove Vehicle Start System25808837Receiver -- Remote Control Door Lock, Remote Entry and Remote VehicleStart System25851460Antenna Asm -- Remote Control Door Lock itter -- with Remote Vehicle Start System15912859Transmitter -- 4-Button with Trunk25808836Receiver -- Remote Control Door Lock, Remote Entry25808837Receiver -- Remote Control Door Lock, Remote Entry and Remote VehicleStart System25851443Antenna Asm -- Remote Control Door Lock ReceiverWarranty yskey 1990156&from bcpi10/24/2008
Document ID: 1990156Page 5 of 5For vehicles repaired under warranty, use:Labor OperationDescriptionLabor TimeRCDLR Module, RCDLR Antenna and RKE Transmitter -ReplaceR9730*Impala / Monte Carlo2.2 hrsDTS1.8 hrsLucerne1.4 hrs* This is a unique labor operation for bulletin use only. It will not be published in the LaborTime Guide.GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to informthese technicians of conditions that may occur on some vehicles, or to provide information that could assist in theproper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-howto do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, orthat your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefitfrom the Syskey 1990156&from bcpiWE SUPPORTVOLUNTARYTECHNICIANCERTIFICATION10/24/2008
Oct 24, 2008 · 2006-2007 Cadillac DTS 2006-2007 Chevrolet Impala, Monte Carlo DTS / Lucerne: 5/1/07 Impala / Monte Carle: 3/1/07 The remote keyless entry (RKE) transmitters will not program, function and/or the RKE transmitter low battery message is displayed
VIZIO Universal Remote Control. With this Universal Remote, juggling multiple remote controls is a thing of the past! Your new remote controls up to 3 devices, including the most popular brands of TV, Blu-Ray, DVD, DVR, Cable, and more. Note: Some functions from your original remote may not be controlled by this remote. Use the original remote, if
Then, use the "remote desktop" software to “connect-in” to your shack PC. You “see” the shack desktop, and control the station, just like being there. 9 #3. Remote Desktop software There are many good free “Remote desktop“ programs (also called VNC): TeamViewer, Chrome Remote Desktop, Windows Remote Desktop, Splashtop,
Your new AT8560Ž AllTouch fi Universal Remote Control (remote) is a true universal remote, functioning as Þ ve remotes in one. As one example, you can use this remote to operate your TV, VCR, DVD player, set-top, and receiver. Important Information About Your Remote Your remote is initially programmed to only operate your set-top. The Volume .
What is Interactive Remote Access . Interactive Remote Access - Effective 4/1/16- Interactive Remote Access. is defined as: "User-initiated access by a person . employing a remote access client or other remote access technology . using a routable protocol. Remote access originates from a Cyber Asset. that is . not. an . Intermediate System .
C2 Appendix C Remote Desktop and Remote Assistance Figure C.2 With Remote Desktop, you can use your own computer from any computer running Windows or Mac OS X. Remote Desktop works in much the same way as other remote control products such as VNC, PCAnywhere, and CarbonCopy. Personally, it seems to me to be somewhat faster than these other
OEM Remote Starter Detection How to Know if the vehicle is Equipped with an OEM Remote Starter 1. An “ENGINE STARTER” sticker should be on the remote. ENGINE STARTER 2. Remote start the OEM remote starter: Press the remote control’s lock button twice within 2 seconds, then press and hold the lock button for 3 seconds. x2 & Press & Hold .
Initializing The Remote Control 1. Turn on the electrical power at the circuit breaker. 2. Slide open the battery cover on the back of the remote transmitter. 3. Install one 9 volt battery into the remote control. Replace the battery cover. . Remote Control Operation The fireplace is supplied with a radio frequency remote control. This remote .
Financial accounting provides the rules and structure for the conveyance of financial information about businesses (and other organizations). At any point in time, some businesses are poised to prosper while others teeter on the verge of failure. Many people are seriously interested in evaluating the degree of success achieved by a particular organization as well as its . Saylor URL: http .
