TECHNICAL SERVICE BULLETIN 18-2273 Intermittent Grinding .

2y ago
30 Views
2 Downloads
333.10 KB
5 Pages
Last View : 2d ago
Last Download : 2m ago
Upload by : Cannon Runnels
Transcription

Page 1 of 5TECHNICAL SERVICE BULLETINIntermittent Grinding Noise From Integrated Wheel Ends (IWEs)While Driving In Two Wheel Drive (2WD)18-227317 September 2018Model:Ford2013-2018 Expedition2013-2018 F-150Lincoln2013-2018 NavigatorIssue: Some 2013-2018 F-150/Expedition/Navigator vehicles may exhibit an intermittent grinding noisecoming from the right or left IWE area in 2WD mode.Action: Follow the Service Procedure steps to correct the condition.PartsPart NumberDescriptionQuantityHL1Z-3C247-B Clutch Ring Kit (All Models)1BL3Z-3A788-A Check Valve (Tube Assembly) (2013-2014 F-150)1FL3Z-3A788-A Check Valve (Tube Assembly) (2015-2018 F-150, Sep 2017-2018Expedition/Navigator)1AL3Z-3A788-A Check Valve (Tube Assembly) (2013-Aug 2017 Expedition/Navigator)1W520215S441Front Tie Rod Nut (2013-2014 F-150, 2013-2017 Expedition/Navigator)W520215S441Front Upper Ball Joint Nut (2013-2014 F-150, 2013-2017Expedition/Navigator)W520215S440Front Tie Rod Nut (2015-2018 F-150, 2018 Expedition/Navigator)W520214S440Front Upper Ball Joint Nut (2015-2018 F-150, 2018 Expedition/Navigator)W714743S439Front Brake Caliper Bolts (2013-2014 F-150, 2013-2018Expedition/Navigator)W718303S439Front Brake Caliper Bolts (2015-2018 F-150)222212CL3Z-1104-M Front Hub Bearing (2013-2015 Early Build F-150)2FL3Z-1104-HFront Hub Bearing (Late Build 2015-2018 F-150)2CL3Z-1104-LFront Hub Bearing (2017-2018 F-150 Raptor)2CL3Z-1104-NFront Hub Bearing (2013-2014 Expedition/Navigator)2FL1Z-1104-HFront Hub Bearing (2015-2018 Expedition/Navigator)27L1Z-3C247-A Actuator Assembly (2013-2015 F-150 Expedition Navigator)2HL1Z-3C247-A Actuator Assembly (2016-2018 F-150 Expedition Navigator)2http://www.fordservicecontent.com/Ford Content/vdirsnet/TSB/EU/ WTSB18-2273/US/.3/18/2019

Page 2 of 5W706890S439Wheel Bearing Bolts (All Models)4N802827-S100 Front Halfshaft Nut (2013-2015 F-150/Expedition/Navigator)N802827S100AFront Halfshaft Nut (2016-2018 F-150/Expedition/Navigator)XG-1-E1Motorcraft Premium Long-Life Grease221Warranty Status: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage Warranty/ESPcoverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits aredetermined by the identified causal part and verified using the OASIS part coverage tool.Labor TimesOperationNo.DescriptionTime2013-2018 F-150, Expedition/Navigator 4X4: Replace Check Valve, Apply VacuumTo Both (2) IWEs (Both Pass) Road Test (Pass) (Do Not Use With Any Other LaborOperations)182273A0.7Hrs.2013-2018 F-150, Expedition/Navigator 4X4: Replace Check Valve, Apply VacuumTo Both (2) IWEs (One Fail) Remove One IWE, Inspect Wheel Bearing Splines(Pass) Replace One (1) IWE (Do Not Use With Any Other Labor Operations)182273B1.0Hrs.2013-2018 F-150, Expedition/Navigator 4X4: Replace Check Valve, Apply VacuumTo Both (2) IWEs(Both Fail) Remove Both IWEs, Inspect Wheel Bearing Splines(Both Pass) Replace Both (2) IWEs (Do Not Use With Any Other Labor Operations)182273C1.7Hrs.2013-2018 F-150, Expedition/Navigator 4X4: Replace Check Valve, Apply VacuumTo Both (2) IWEs (Both fail) Remove IWEs, Inspect Wheel Bearing Splines (OneFail) Replace One (1) Wheel Bearing And One (1) IWE (Do Not Use With Any OtherLabor Operations)182273D1.8Hrs.2013-2018 F-150, Expedition/Navigator 4X4: Replace Check Valve, Apply VacuumTo Both (2) IWEs (Both fail) Remove IWEs, Inspect Wheel Bearing Splines (BothFail) Replace Both (2) Wheel Bearings And Both (2) IWEs (Do Not Use With AnyOther Labor Operations)182273E2.0Hrs.2013-2018 F-150, Expedition/Navigator 4X4: Replace Check Valve, Apply VacuumTo Both (2) IWEs (Both Pass) Road test (Fail One Side) Remove IWE, InspectWheel Bearing Splines (Pass) Replace One (1) IWE Clutch Ring (Do Not Use WithAny Other Labor Operations)182273F1.5Hrs.2013-2018 F-150, Expedition/Navigator 4X4: Replace Check Valve, Apply VacuumTo Both (2) IWEs (Both Pass) Road test (Fail Both Sides) Remove Both IWEs,Inspect Wheel Bearing Splines (Pass) Replace Both (2) IWE Clutch Rings (Do NotUse With Any Other Labor Operations)182273G2.2Hrs.2013-2018 F-150, Expedition/Navigator 4X4: Replace Check Valve, Apply VacuumTo Both (2) IWEs (Both Pass) Road Test (fail One Side) Remove IWE, InspectWheel Bearing Splines (Fail One Side) Replace One (1) Wheel Bearing And One (1)IWE Clutch Ring (Do Not Use With Any Other Labor Operations)182273H1.7Hrs.2013-2018 F-150, Expedition/Navigator 4X4: Replace Check Valve, Apply VacuumTo Both (2) IWEs (Both Pass) Road test (Fails Both Sides) Remove Both IWEs,Inspect Wheel Bearing Splines (Fail Both Sides) Replace Both (2) Wheel BearingAnd Both (2) IWE Clutch Rings (Do Not Use With Any Other Labor Operations)182273J2.5Hrs.Repair/Claim CodingCausal Part:3C247Condition Code: D4http://www.fordservicecontent.com/Ford Content/vdirsnet/TSB/EU/ WTSB18-2273/US/.3/18/2019

Page 3 of 5Tool ListDriveTool Name1/4"Power Tool1/4"Torque Wrench1/4"7 mm Socket3/8"Power Tool3/8"Torque Wrench3/8"10 mm Socket3/8"13 mm Socket3/8"19 mm Socket1/2"Impact Wrench1/2"Torque Wrench1/2"21 mm Socket1/2"21 mm Deep SocketMedium Trim ToolService Procedure1. Inspect the IWE vacuum hoses. Refer to Workshop Manual (WSM), Section 308-07A. Are there anydisconnected or damaged vacuum hoses? (Figure 1)(1). Yes - this article does not apply. Refer to WSM, Section 308-07A for normal diagnostics.(2). No – proceed to Step 2.Figure 1http://www.fordservicecontent.com/Ford Content/vdirsnet/TSB/EU/ WTSB18-2273/US/.3/18/2019

Page 4 of 5ItemDescription1IWEs (spring loaded vacuum hubs)2Vacuum hoses3IWE solenoid4Vacuum reservoir2. Replace the vacuum check valve located near the vacuum canister brake booster area. Refer to WSM,Section 308-07A. (Figure 2)Figure 23. Using a hand vacuum pump attached to the IWE one side at a time, apply 67 kPa (20 in Hg) of vacuum.Does the vacuum maintain or drop less than 1.7 kPa (0.5 in Hg) per minute?(1). Yes - proceed to Step 6.(2). No – proceed to Step 4.4. Remove the IWE assembly from the affected wheel. Refer to WSM, Section 308-07A.5. Inspect the wheel bearing splines. Is wheel bearing spline damage found?(1). Yes - replace the IWE assembly and wheel bearing. Refer to WSM, Section 308-07A and 204-01B.Repair is complete.(2). No - replace the IWE assembly. Refer to WSM, Section 308-07A. Repair is complete.6. Road test the vehicle for noise by performing heavy accelerations and engage 4WD system to verifyproper engagement/disengagement quality. Is a grinding noise present?(1). Yes – proceed to Step 7.(2). No – repair is complete.7. Remove the IWE assembly from the affected wheel. Refer to WSM, Section 308-07A.8. Inspect the wheel bearing splines. Is wheel bearing spline damage found?(1). Yes - replace the IWE clutch ring and wheel bearing. Refer to WSM, Section 308-07A and 20401B.(2). No - replace the IWE clutch ring. Refer to WSM, Section 308-07A.http://www.fordservicecontent.com/Ford Content/vdirsnet/TSB/EU/ WTSB18-2273/US/.3/18/2019

Page 5 of 5 2018 Ford Motor CompanyAll rights reserved.NOTE: The information in Technical Service Bulletins is intended for use by trained, professional technicians with the knowledge,tools, and equipment to do the job properly and safely. It informs these technicians of conditions that may occur on some vehicles, orprovides information that could assist in proper vehicle service. The procedures should not be performed by "do-it-yourselfers". Donot assume that a condition described affects your car or truck. Contact a Ford or Lincoln dealership to determine whether theBulletin applies to your vehicle. Warranty Policy and Extended Service Plan documentation determine Warranty and/or ExtendedService Plan coverage unless stated otherwise in the TSB article. The information in this Technical Service Bulletin (TSB) wascurrent at the time of printing. Ford Motor Company reserves the right to supersede this information with updates. The most recentinformation is available through Ford Motor Company's on-line technical resources.http://www.fordservicecontent.com/Ford Content/vdirsnet/TSB/EU/ WTSB18-2273/US/.3/18/2019

AL3Z-3A788-A Check Valve (Tube Assembly) (2013-Aug 2017 Expedition/Navigator) 1 W520215-S441 Front Tie Rod Nut (2013-2014 F-150, 2013-2017 Expedition/Navigator) 2 W520215-S441 Front Upper Ball Joint Nut (2013-2014 F-150, 2013-2017 Expedition/Navigator) 2 W520215-S440 Front Tie Rod Nut (2015-2018 F-150, 2018 Expedition/Navigator) 2 W520214-S440

Related Documents:

technical service bulletin . page 1 of 2. this is a replacement technical . september 23, 2019 . . o customer service service bulletin and supersedes the original technical service bulletin number 225- 1025. you must have this technical service bulletin 225-v21025 completed.

WAGO Compact és univerzális vezeték összekötők Csomag rendelési szám: 51218330 Cikkszám Darabszám 222-412 100 SAMSUNG okos telefon 222-413 500 222-415 160 2273-203 1 500 2273-205 2 000 SAMSUNG S 7582 Galaxy S Duos 2(Dual SIM), black, kátyafüggetlen okos telef

Technical Service Bulletin Audi 91 MMI 3G MMI inop; blank screen at startup; various technical issues (K0942 ZUG update; supersedes K0814 update) 91 16 67 2030465/10 August 18, 2016. Supersedes Technical Service Bulletin Group 91 number 16-49 dated June 23, 2016 for reasons listed below. Model(s) Year VIN Range Vehicle-Specific Equipment

The following service bulletins can be found at quickserve.cummins.com. Q Technical Service Bulletin 150002: Diesel Exhaust Fluid (DEF) Cleanliness Q Technical Service Bulletin 140093: Recommended Practices If Contamination Is Found Q Technical Service Bulletin 110168: High-

"KB", or "XB" mark already complied with this Service Bulletin. B. Description This Service Bulletin provides instructions to identify and replace the fuel manifold listed in paragraph 1.A., Effectivity. C. Compliance Category 2 GE recommends that you do this Service Bulletin as soon as possible without effect on revenue service but before 60 days

The Bureau of Electronic & Appliance Repair Home Furnishings & Thermal Insulation (BEARHFTI) prepared this Initial Study (IS) to evaluate the potential environmental effects of adopting updates to Technical Bulletin 117 and its associated rulemaking. Updates to the bulletin itself are labeled as Technical Bulletin 117-2013 or TB 117-2013.

Technical Service Bulletin 97 No start (DTC P068A00) 97 14 43 2036764/3 April 14, 2014. Supersedes Technical Service Bulletin Group 97 number 14-42 dated March 31, 2014 for reasons listed below. Model(s) Year VIN Range Vehicle-Specific Equipment A4 2009 - 2014 All Not Applicable A5 2009 - 2014 All Not Applicable

Bulletin No.: 19-NA-078 June, 2020 Page 3 - Tire tread depth measurements MUST be provided in the technician cause comments of the transaction. Tires replaced under this bulletin may be subject to request of return for engineering review as noted in the latest version of bulletin# 00-03-10-003 (in