Lionel 180-Watt PowerHouse Power Supply Owner’s Manual
72-2983-25010/06Lionel180-Watt PowerHousePower SupplyOwner’s ManualCAUTION—ELECTRICALLY OPERATED PRODUCTNOT RECOMMENDED FOR CHILDREN UNDER EIGHT YEARS OF AGE. AS WITHALL ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE OBSERVED DURINGHANDLINGAND USETO PREVENT ELECTRIC SHOCK.TRANSFORMER RATINGS—INPUT:120VAC; 60 HZ ONLY.AC OUTPUT:18V; 180VA
Congratulations!Congratulations on your purchase of the Lionel 180-Watt PowerHouse Power Supply! ThePowerHouse Power Supply generates a brawny 180 watts (ten amps) of alternating current.Designed for use with the TMCC PowerMaster, the Track Power Controllers, the modern ZW, orthe Direct Lockon, this power supply features an ON/OFF switch and a circuit breaker for safeoperation.Table of contentsOperating your PowerHouse Power Supply safely3Powering the TMCC PowerMaster4Powering the Track Power Controller4-6Powering the ZW Transformer7Installing your TMCC Direct Lockon8-9Resolving short circuits10Notes11Limited Warranty/Lionel Service12The following Lionel marks may be used throughout this instruction manual and are protected under law.All rights reserved.Lionel , TrainMaster , Odyssey , RailSounds , CrewTalk , TowerCom , DynaChuff ,StationSounds , Pullmor , ElectroCoupler , Magne-Traction , CAB-1 Remote Controller,PowerMaster , Lionel ZW , ZW , PowerHouse , TMCC , Lionelville , Lockon , Wireless Tether ,LionMaster , FatBoy , American Flyer , TrainSounds , PowerMax The name FasTrack is used with permission from Pitsco, Inc.2
Operating your PowerHouse Power Supply safelyWarning! When using electrical products, follow these basic safety precautions: Read these instructions thoroughly before using this device. The PowerHouse Power Supply is not recommended for children under eight years of age. Parents should periodically inspect the PowerHouse Power Supply for potential hazards andhave them repaired by an authorized Lionel Service Center. In the event that such acondition exists, the PowerHouse Power Supply should not be used until it has been properlyrepaired. The PowerHouse Power Supply is intended to be used indoors. Do not use the PowerHousePower Supply if water is present. Serious or fatal injuries may result. Do not use the PowerHouse for anything other than its intended purpose. This unit wasdesigned to operate with select Lionel controllers only. The PowerHouse Power Supply was designed to operate on 120-volt, 60-Hz power. Do notconnect the PowerHouse Power Supply to any other source of power. Do not operate the PowerHouse Power Supply with a damaged cord, plug, or case. To avoid the risk of electrical shock, do not disassemble the PowerHouse Power Supply.There are no user-serviceable parts inside. If damaged, take the unit to an authorized LionelService Center. A list of authorized Service Centers is included.Do not operate your railroad unattended. Obstructed accessories or stalled trainsmay overheat, resulting in damage to your layout. If the circuit breaker trips, turn the PowerHouse Power Supply OFF. Reset the circuit breaker,then turn the power ON and resume operation. Resetting the circuit breaker duringoperation may cause the train to surge forward. Unplug the PowerHouse Power Supply from the power source when not in use.Caution!3
Powering the TMCC PowerMasterAs illustrated in Figure 1, connect the plug from the PowerHouse Power Supply to thecorresponding receptacle on the PowerMaster unit. Note that the plug and the receptacleare keyed to fit only one way.Plug in your PowerHouse Power Supply to a standard wall outlet and switch on thePowerHouse Power Supply. The PowerMaster’s green power-on indicator illuminates to indicatethat it is receiving power. If the indicator does not illuminate, check the connection and be surethat the PowerHouse Power Supply is plugged in. Refer to the PowerMaster Owner’s Manual foradditional information.Note! Be sure to throw the PowerMaster’s power switch to 180 if the PowerMaster isequipped with the switch.PowerMasterreceptablePowerMaster UnitPowerHouseplugFigure 1. PowerMaster connectionPowering the Track Power ControllerThe PowerHouse Power Supply connections are made on the back panel of the Track PowerController (TPC) unit. These terminals are labeled HOT and NEUT under POWER IN. YourPowerHouse Power Supply will power both the TPC unit and the track to which the TPC isconnected. Keep in mind that you may power the TPC unit with two PowerHouse PowerSupplies. Be sure to use two of the same type of PowerHouse Power Supplies (e.g., two 180-wattunits).4
Powering your Track Power Controller (continued)Wiring the TPC unit with a single PowerHouse Power SupplyNote! To wire the TPC unit with a single PowerHouse, you will need to use the cables withthe two adapters from the TMCC TPC Cable Set (available separately, 6-14194).1. Plug the power output cable on the PowerHouse Power Supply into the adapter on the TMCCTPC Cable.2. Attach the black wire to the HOT terminal on the TPC unit, located under the POWER INlabel.3. Attach the white wire to the NEUT terminal on the TPC unit.INER TWHOPOTUTOU NEKAC URTATPCMM MCO CO -TDAXAUXAUHotNeut180-Watt PowerHousePower SupplyFigure 2. Powering your TPC with a single PowerHouse Power Supply5
Powering your Track Power Controller (continued)Wiring the TPC unit with two PowerHouse Power SuppliesNote! To wire the TPC unit with two PowerHouses, you will need to use the cable with twoadapters from the TMCC TPC Cable Set (available separately, 6-14194).1. Plug the power output cables on the PowerHouse Power Supplies into the adapters on theTMCC TPC Cable.2. Attach the black wire to the HOT terminal on the TPC unit, located under the POWER INlabel.3. Attach the white wire to the NEUT terminal on the TPC unit.Note! Wire similar PowerHouse Power Supplies only. Do not wire a 135-Watt PowerHousewith a 180-Watt PowerHouse.TPCNEUTHOTINER TWHOPOTUTOU NEKAC UTRA-MM MCO COX AUTDAXAU1212180-Watt PowerHousePower SuppliesFigure 3. Powering your TPC with two PowerHouse Power Supplies6
Powering the ZW TransformerYou may also use the PowerHouse Power Supply with your modern ZW Transformer. Removea jumper and connect the PowerHouse Power Supply as illustrated in Figure 4. Refer to theZW Transformer’s Owner’s Manual for additional information.PROGRAMCUUOMMUONUDCBAJumpersRear view of ZW TransformerInsert 180-Watt PowerHouse Power Supply connectorplug into ZW input jack.Figure 4. Powering the ZW Transformer with the PowerHouse Power Supply7
Installing your TMCC Direct LockonThe PowerHouse Power Supply and Command Base connections are found inside of thestructure. Follow these steps and refer to Figure 5 as you make these connections.1. Remove the four screws from the bottom of the Lockon structure.2. Remove the base and lift the structure off of the circuit board.3. Insert the PowerHouse plug into the receptacle on the circuit board.4. Attach the Command Base wire to the spring clip terminal.Press down on the top of the terminal clip so that a metal loop is formed. Slide the bare endof the wire into the exposed loop. Release pressure on the terminal clip, allowing thecrimped metal to pinch the end of the wire in the metal loop. Give a little tug on the wire tobe sure that the hold is secure.5. Use the switch to select the type of PowerHouse that you are using.Slide the switch to 180 for the 180-Watt PowerHouse.6. Route the PowerHouse cord and the Command Base wire through the slotas illustrated in Figure 5 on page 9.7. Replace the structure and the base, securing them with the four screws.8. Connect the Direct Lockon to your track as described in the Owner’sManual.8
Installing your TMCC Direct Lockon (continued)Connect Command Basewire here180W135WInsertPowerHouseplug hereLionelPowerHouseLionelCommand BaseFigure 5. Direct Lockon connections and switch location9
Resolving short circuitsDerailments, metal objects on the track, and improper wiring may cause a short circuit.Short circuits will trip the circuit breaker on the PowerHouse Power Supply. If the circuitbreaker is tripped, turn off the PowerHouse Power Supply and then correct the short circuit.After the short circuit has been corrected, press in the circuit breaker and turn on thePowerHouse Power Supply.Caution!Do not attempt to operate the PowerHouse Power Supply until the short circuithas been removed.10
Notes11
Limited Warranty/Lionel ServiceThis Lionel product, including all mechanical and electrical components, moving parts, motors andstructural components, except for light bulbs, is warranted to the original consumer-purchaser, for oneyear against original defects in materials or workmanship when purchased through an authorized Lionelmerchant.This warranty does NOT cover normal wear and tear, light bulbs, defects appearing in the course ofcommercial use, or damage resulting from abuse or misuse of the product by the purchaser. Transfer of thisproduct by the original consumer-purchaser to another person voids this warranty. Modification of this productvoids this warranty.Any warranted product which is defective in original materials or workmanship and is delivered by theoriginal consumer-purchaser to Lionel L.L.C. or an authorized Lionel L.L.C. Service Center, together with proof oforiginal purchase will, at the option of Lionel L.L.C., be repaired or replaced, without charge for parts or labor. Inthe event the defective product cannot be repaired, and a replacement is not available, a refund of the originalpurchase price will be granted. Any products on which warranty service is sought must be sent freight or postageprepaid, as transportation and shipping charges are not covered by the warranty.In no event shall Lionel L.L.C. be liable for incidental or consequential damages.Some states do not allow the exclusion or limitation of incidental or consequential damages, so the aboveexclusion may not apply to you.This limited warranty gives you specific legal rights, and you may have other rights which vary from stateto state.Instructions for Obtaining ServiceIf service for this Lionel L.L.C. product is required, bring the item, along with your dated sales receipt andcompleted warranty information to the nearest Authorized Lionel Service Center. Your nearest Lionel ServiceCenter can be found by calling 1-800-4-Lionel, or by accessing our Website at www.lionel.com.If you prefer to send your product back to Lionel L.L.C. for repair in Michigan, you must first call586-949-4100 or FAX 586-949-5429, or write to Customer Service, P.O. Box 748, New Baltimore, MI48047-0748, stating what the item is, when it was purchased and what seems to be the problem. You will be senta return authorization letter and label to ensure your merchandise will be properly handled upon receipt.Once you have received your return authorization and label, make sure that the item is packed to preventdamage during shipping and handling. We suggest that you use the product’s original packaging. Thisshipment must be prepaid and we recommend that it be insured.Please make sure you have followed all of the above instructions carefully before returning anymerchandise for service. You may choose to have your product repaired by one of our Authorized Lionel ServiceCenters after its warranty has expired. A reasonable service fee will be charged.Warranty InformationPlease complete the information below and keep it, along with your dated sales receipt. You must presentthis and your dated sales receipt when requesting warranty service.NameAddressPlace of PurchaseDate of PurchaseProduct NumberProduct Description 2006 LIONEL L.L.C., CHESTERFIELD, MI 48051-2493UNITED STATES OF AMERICAPRINTED IN CHINA
Lionel 180-Watt PowerHouse Power Supply Owner’s Manual 72-2983-250 10/06 CAUTION—ELECTRICALLYOPERATEDPRODUCT NOTRECOMMENDEDFOR CHILDREN UNDER EIGHTYEARS OFAGE.ASWITH
ac output : 18v, 180 va per channel (with 180 watt powerhouse) 4 channel controller lionel zw controller and powerhouse power supply set 72-2982-250 7/03 not recommended for children under eight years of age. as with all electric products, precautions should be observed during handling and use to reduce the risk of electric shock.
The Powerhouse Alliance The Powerhouse Alliance includes the companies: Snøhetta Architects, Skanska, Hydro, Entra Eiendom and the NGO Zero. The Powerhouse concept was first launched in 2011. The proposal for the first Powerhouse project, a new office building in Trondheim, was presented in 2012. The Powerhouse Kjørbo is the first renovation
PROFAX NO. DESCRIPTION I.D. O.D. PROFAX NO. DESCRIPTION TF-180 Flexible barrel TFX-180 Flexible barrel for extreme heat PROFAX NO. DESCRIPTION 180-45J Jacketed conductor tube 45 180-60J Jacketed conductor tube 60 180-180J Jacketed conductor tube 180 PROFAX NO. DESCRIPTION 180-45 Conductor tube 45 180-60 Conductor tube 60 180-180 .
Page 1 Rev 2.0 12/12/12 Lionel FasTrack Modular Railroad Specifications Introduction From the beginning, the Lionel FasTrack Modular Railroad has been a joint effort between Lionel L.L.C. and the Lionel Collectors Club of America.
The People’s Powerhouse puts people at the heart of the Northern Powerhouse agenda. What started on social media discussing gender imbalance at one event, soon became a focal point for many about the need to shift the focus of Northern Powerhouse discussions on physical infrastructure and economic growth. The People’s Powerhouse tapped into
The powerhouse made power until October 10, 1938 when all power production was shifted to a powerhouse at Kent Avenue. Between 1938 and 1972 it was used to generate DC for trolleys in the area and to power sections of the Fourth Avenue BMT subway. In the mid-1970s operations at the powerhouse ceased and all of the equipment was removed.l
pro ramachandran plot Andrew Torda 27.11.2019 [ 34 ]-180-120-60 0 60 120 180-180 -120 -60 0 60 120 180 ψpsi Φphi all-180 amino acids-120-60 0 60 120 180 ψpsi Φphi. gly glycine no side chain can visit forbidden parts of phi-psi map evolutionary consequences ? Andrew Torda 27.11.2019 [ 35 ]-180-120-60 0 60 120 180-180 -120 -60 0 60 .
Research shows adventure tourism to be a part icularly resilient niche, and when destinations proactively invest in their adventure markets, arrivals increase. For instance, at the AdventureNEXT trade event in May 2018, Jordan’s Tourism minister Lina Annab revealed that subsequent to a focused approach toward adventure tourism development, which included several collaborations with ATTA and .
