K&N Series 69 Typhoon Cold Air Intake (V6 - 11, 12, 13, 14 .

2y ago
19 Views
2 Downloads
673.38 KB
7 Pages
Last View : 1m ago
Last Download : 2m ago
Upload by : Kairi Hasson
Transcription

K&N Series 69 Typhoon Cold Air Intake (V6 - 11, 12, 13, 14)Installation GuideRequired Tools: #3MM Hex#4MM HexFlat Blade ScrewdriverPliers5/16” wrench/socket10MM wrench/socketIncluded Parts: )(6)(6)(1)Hose Clamp #48Hose; 3” ID X 3”L Hump ReinforcedIntake tubeVent; STRT, 3/8” Hose, 1/4 NPT, PlasBolt; M4 - 0.07 8mm, A/H Cap, SSHose; 3-1/2” To 3” ID X 3” L TPRD MoldedHose Clamp #56Bolt; M6 X 1.00 X 16mm , Buttonhead, SSWasher; 1/4” Lock, ZNWasher, 1/4” ID X 5/8” OD- SAENipple, Heat Shield MountAir boxBolt; M6 X 1.00 X 20mm Hex, SSAdapter; Universal, 6” Filter 3.5” CouplerHose Clamp #104Air FilterLidBolt; M5-0.8 X 12mm B/H, SSWasher; 5mm Internal Star Cut LockPlug; 1/4 Npt, Plastic, Blk.

Before:Installation Instructions:1. Disconnect the negative battery cable from the battery by loosening the bolt at the terminaland placing the cable to the side.2. Remove crank case vent hose and the EVAP hose from factory intake by releasing the lockingtabs with a pair of pliers that secure each hose.3. Loosen and remove two 4mm screws using 4mm hex wrench that secure the mass air sensorconnection to factory intake.

4. Release the two clips that secure the upper air box to the lower air box and remove upper airbox assembly from car.5. Use 5/16” socket/wrench to remove the bolt that secures the lower air box to inner fenderand remove the lower air box from car.6. Place silicone hose onto throttle body and loosely tighten screws with flat blade screwdriveron the provided hose clamps.

7. Place mounting studs to the bottom of the K&N air box. You may need to enlarge theprovided holes using a file or large drill bit.8. Remove the factory air box mounting grommets from the factory lower air box and push themonto the mounting studs.9. Place the filter adaptor into the air box and secure with sliding the silicone hose onto theadapter and secure hose clamps by tightening the screws with a flat-blade screwdriver.10. Position the K&N air box so the mounting grommets are inserted into the mounting holes andthen secure the air box with large screw taken from factor air box.

11. Place and tighten the NPT fitting into the K&N intake tube.12. Place the mass air sensor into the K&N intake tube and secure with the two screws two 4mmscrews using 4mm hex wrench that secure the mass air sensor connection to factory intake.13. Put in the K&N intake tube into the silicone hose at throttle body, then into the silicon hoseon the filter adapter. Secure the intake tube with hose clamps by locking the locking tabs witha pair of pliers that secure each hose.

14. Connect the crank case vent hose and EVAP hose to the K&N intake.15. Place the K&N air filter onto the filler adapter and secure hose clamp bolt with flat-headscrewdriver.16. Place the air box cover onto the K&N air filter and tighten 3mm hex bolts with a 3mm hexwrench.17. Double check on all bolts and clamps to make sure everything is airtight.18. Reconnect the car’s negative battery cable by placing the cable onto the terminal andtightening the bolt.19. Start the engine and make sure the car is idling smooth.

After:Installation Instructions written by AmericanMuscle customer Jerry Babcock 6.10.15

11. Place and tighten the NPT fitting into the K&N intake tube. 12. Place the mass air sensor into the K&N intake tube and secure with the two screws two 4mm screws using 4mm hex wrench that secure the mass air sensor connection to factory intake. 13. Put in the K&N intake tube into the s

Related Documents:

and a Super Typhoon has winds of at least 190kmh 1. Typhoon Haiyan traveled at 30– 40kmh 1 with a maximum 1min sustained wind speed of 315kmh 1 (Daniell et al., 2013), reaching Category 5 on the Saffir–Simpson Scale. Typhoon Haiyan hit the small nation of Palau causing som

Super Typhoon Goni in the Philippines. SUPER TYPHOON GONI Super Typhoon Goni tore through the Philippines with 140mph winds and torrential rain on November

EF - 2000 Typhoon Item code: BH165 This instruction manual is designed to help you build a great flying aeroplane. Please read this manual thoroughly before starting assembly of your EF -2000 Typhoon

experience following Typhoon Haiyan This edition of Humanitarian Exchange focuses on lessons from the humanitarian response to Typhoon Haiyan, the worst disaster ever to hit the Philippines. Making landfall on 8 November 2013, the typhoon killed more than 6,000 people and affected more than 14 million. It also triggered

6 2017 EUROFIGHTER WORLD EUROFIGHTER TYPHOON EUROFIGHTER TYPHOON 2017 EUROFIGHTER WORLD 7 A n unidentified aircraft has been tracked in NATO-monitored airspace above the Baltic. Calmly but quickly Luftwaffe pilot Capt Martin Zielinski pulls on his G-suit, while his engineers bring his wait-ing jet to life.

SMB_Dual Port, SMB_Cable assembly, Waterproof Cap RF Connector 1.6/5.6 Series,1.0/2.3 Series, 7/16 Series SMA Series, SMB Series, SMC Series, BT43 Series FME Series, MCX Series, MMCX Series, N Series TNC Series, UHF Series, MINI UHF Series SSMB Series, F Series, SMP Series, Reverse Polarity

3 www.understandquran.com ‡m wQwb‡q †bq, †K‡o †bq (ف ط خ) rُ sَ _ْ یَ hLbB َ 9 آُ Zviv P‡j, nv‡U (ي ش م) اْ \َ َ hLb .:اذَإِ AÜKvi nq (م ل ظ) َ9َmْ أَ Zviv uvovj اْ ُ Kَ hw ْ َ Pvb (ء ي ش) ءَ Cﺵَ mewKQy ءٍ ْdﺵَ bِّ آُ kw³kvjx, ¶gZvevb ٌ یْ"ِKَ i“Kz- 3

Typhoon Haiyan (2013) Causes Typhoon Haiyan was a tropical cyclone that affected the Philippines in South East Asia in November 2013. It was one of the strongest tropical cyclones ever recorded with winds of 313 km/h. In some areas, 281.9 mm of rainfall was recorded, much of which fell in under 12 hours.