Aftermarket-Page 3
plug the aftermarket radio harness into the aftermarket radio. 3. Reconnect the negative battery terminal. 4. Cycle thekey,byturningtheignition onfor30seconds.Thenoffand again to test the radio. Testing the GMOS-LAN-012. 1. Turn the ignition on, and then turn the aftermarket radio on. 2.
aftermarket drivetrain products by Dana Dana-Engineered for the Aftermarket. Built with Integrity. Engineered by Dana. Spicer Select drivetrain products are purpose-built using Dana data, testing, and expertise to ensure optimal fit and performance. Our drivetrain products are designed to engineering standards you and your customers
findings from Frost & Sullivan's latest research on e-retailing in the UK automotive aftermarket. The scope of this report is limited to the aftermarket for passenger cars and excludes motorcycles, commercial vehicles, buses and off-highway vehicles. 1 Based on average frequency of 1.15 workshop visits per car, per year
quality aftermarket parts that can be pur-chased and live up to all the expectations of the original at a much lower price. In both cases, OEM and aftermarket parts, the part should perform the function it was designed for, so the car owner will decide which part to choose [4]. Over the years, supply chain in automotive
5. If the vehicle is equipped with a reverse camera and the aftermarket radio has a reverse camera input, connect the yellow RCA plug on the brown connector to the aftermarket radios reverse camera input. 6. If the aftermarket radio is equipped with an auxiliary input and you wish to retain the factory XM tuner, plug the RCA connectors from the
Phone: 800-521-0546 E-mail: sales@pcs-company.com Fax: 800-505-3299 www.pcs-company.com AFTERMARKET PARTS & SERVICES AFTERMARKET PARTS & SERVICES N6 OEM Heaters DME and Husky equivalent replacement heaters
Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation. 2 Slide the aftermarket head unit into the cage and secure. (Figure C) 4 *Note: Refer also to the instructions included with the aftermarket radio.
From the 28-pin harness, to the aftermarket radio: Connect the Green/Purple wire to the reverse wire. Connect the White and Red RCA to the audio AUX in to retain the OE 3.5mm jack (if equipped). With all connections completed to the aftermarket radio, plug the 28-pin and 10-pin harness into the vehicles wiring harness.
DOWNLOAD MANUAL HERE www.CrossCreekTractor.com Call Us: 1 (800) 462-7335 AFTERMARKET TRACTOR PARTS FOR CASE - IH ALL PARTS LISTED ARE AFTERMARKET REPLACEMENT PARTS AND ARE NOT PRODUCED BY THE ORIGINAL EQUIPMENT MANUFACTURER . B414, 424, 444, 354, 365, 384, 3414, 2424, 2444, 238, 500, TD5 BD144/BD154 Diesel Engine EOKiHBD154A Engine Overhaul .
7 Connections to be made Installing the interface From the 7803 harness to the aftermarket radio: Connect the Black wire to the ground wire. Connect the Yellow wire to the battery wire. Connect the Red wire to the accessory wire. Connect the Blue wire to the power antenna wire. If the aftermarket radio has an illumination wire, connect the Orange wire to it.
For models without a Sony amplifier: From the 16-pin harness with stripped leads to the aftermarket radio: Connect the Red wire to the accessory wire. If equipped with a factory subwoofer, connect the Blue/White wire to the amp turn on wire. If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
Use Harley Davidson replacement fasteners. Aftermarket fasteners can adversely affect performance, which could result in death or serious injury. (00013a) See your Harley Davidson service manual for proper torque values. Aftermarket fasteners may not have the specific property requirements to perform properly.