Treadmill-Page 2

Place the treadmill on a level and stable surface away from direct sunlight. The intense UV light can cause discoloration on the plastics. Locate your treadmill in an area with cool temperatures and low humidity. Please leave a clear zone behind the treadmill that is at least the width of the treadmill and at least 79" (2000 mm) long.

Power the treadmill on by plugging it into an appropriate wall outlet, then turn on the power switch located at the front of the treadmill below the motor hood. Ensure that the safety key is installed, as the treadmill will not power on without it. When the power switch is turned on the treadmill console will take around 10 seconds to power on. The

This treadmill is intended for commercial use. To ensure your safety and protect the equipment, read all instructions before operating the Matrix Treadmill. Please leave a 78.75" (2000 mm) x 39.50" (1000 mm) landing zone behind the treadmill. This zone is to allow easy access to the treadmill and gives the user an easy exit path from the .

the treadmill on any surface that blocks air openings. To protect the floor or carpet from damage, place a mat under the treadmill. 8. Do not operate the treadmill where aerosol products are used or where oxygen is being administered. 9. Keep children under age 13 and pets away from the treadmill at all times. 10. The treadmill should be used .

3. Assemble and operate the treadmill on a solid level surface. Position the treadmill with a minimum of 20 inches of clearance on each side to allow for ease of mounting and dismounting. Allow for 48 inches of clearance behind the treadmill. Keep the power cord away from heated surfaces. Unplug the power cord when the treadmill is

Before leaving the treadmill unattended, always wait until the treadmill comes to a complete stop and is level. Then, turn all controls to the STOP or OFF position and remove the plug from the outlet. Remove the e-stop key from the treadmill. Immobilize the treadmill (when not in use) by removing the e-stop key.

Cybex 750T Treadmill Service Manual Safety Page 1-3 Keep the running belt clean and dry at all times. DO NOT leave the treadmill unattended when plugged in and running. NOTE: Before leaving the treadmill unattended, always wait until the treadmill comes to a complete stop and is level.

3. Use the treadmill indoors on a level surface, and keep at least 3 feet of free space all around it. 4. Check the treadmill regularly for damage, wear or tear. Replace defective components immediately. If there are any defective components, do not use the treadmill. 5. Keep children away from the treadmill at all times. 6.

Keep the treadmill indoors, away from moisture and dust. Do not put the treadmill in a garage, covered patio or near water. 9. Do not operate the treadmill where aerosol products are used or where oxygen is being administered. 10. Read, understand and test the emergency stop procedure before using the treadmill (see operation and adjustment on .

place a mat beneath your treadmill. #! Locate the treadmill at least 4 feet from walls or furniture. #! Allow a safety area of 20m X 10m behind the treadmi ll so that you can easily get on and off the treadmill without getting trapped durin g an emergency. Occasionally after extended use you will find a fin e black dust below your treadmill.

the treadmill on any surface that blocks air openings. To protect the floor or carpet from damage, place a mat under the treadmill. 6. Do not operate the treadmill where aerosol products are used or where oxygen is being administered. 7. Keep children under age 12 and pets away from the treadmill at all times. 8. The treadmill should be used .

3 Failure to leave ample clearance around the treadmill could result in the user becoming trapped between the treadmill and a wall, resulting in burns or other serious injury from the moving treadbelt. Allow a minimum clearance of 18 inches on each side of the treadmill. Allow a minimum clearance of 4 feet at the rear of the treadmill.