CB Modifications This Information Is Supplied For
CB ModificationsSida 1 av 8CB ModificationsThis information is supplied foreducational purposes onlyPlease Remember this information is for educational purposes only and isnot an endorsement of the information supplied.I assume no liability or responsibility with respect to the use of suchinformation.Expanding the MB8719Models include:- Uniden Grant/Madison, Cobra 148/2000 GTL etc.Note: Some newer Uniden's now have the RCI8719 'clone' Pll. You willhave to replace the PLL with the old MB8719 BEFORE attempting thesemods.To get coverage from 27.455 - 28.045, find the MB8719 PLL, then locatepins 10,11and 12. Cut the track going to these pins. Locate a ground (chassisor track) .Using a DPDT Center off switch, connect the switch to pins10,11,12(IC side of the cut) on the MB8719 PLL.This Mod will give you thenormal 'FCC' channels in the center position. In the Down position 27.605 28.045, In the up position 27.455 - 27.605( on channels 2 -14).See diagrambelow.Further expansion can be done by replacing the loop mixer crystal, givingyou a new set of 40 channels per crystalhttp://4.3.101.244/mods cb.html2004-04-07
CB ModificationsSida 2 av 8Expanding the Cobra 148GTL-DX/Superstar 360FM(PB010)Clip off the YELLOW, WHITE, & PINK wires from the ch.9 panel switch.Reconnect WHITE & PINK together for normal LED channel display. Cutoff the GRAY wire from the HI/LO TONE panel switch. Remove thegrounding jumper at pin 9 of the MC145106 PLL chip. Connect a small barewire between the center terminals of the now free poles of the CH.9 &TONE switches. Add the two 1N914 diodes and additional switch wiring asshown belowThe extra frequencies will now appear in the Ch.12-40 positions of theCHANNEL SELECTOR with the BAND selector in the HIGH position. (Thefirst 11 channels are repeats of existing channels.)The "ch9" positionactivates the expansion. In the LO TONE position you will get 28.195 Mhz(ch.12) to 28.495(ch.40).if you pull IC7 pins 4 & 2 HIGH at the same timeyou will get coverage up to 28.705 Mhz. This would need a three positionswitch.Emperor 50101. Remove the four screws holding the bottom cover in place.2. Lift the bottom cover enough to clear the case and slide it to the sidewhile being careful not to detach the speaker wires.3. You should now see the PLL/CPU board at the front of the radio.4. With the front of the radio facing you, locate R539 and R540 at thelower right corner of the large chip(HD614081), R539/R540 are sideby side and very small.5. Remove R539 and R540. You now will get 26.500Mhz to 27.999Mhzplus the 'FCC' band in nine bands.http://4.3.101.244/mods cb.html2004-04-07
CB ModificationsSida 3 av 8Galaxy 991. Remove the case and find the small circuit board (EOT004410Z)connected to the left side of the radio as viewed from the componentside of the main chassis.2. Find the wire that is connected to this circuit board(in step 1).Removethis wire.3. Remove the small screw that holds the small board on to the chassis.4. Under this board you will find a 7 pin plug that is not connected toanything. Insert this plug into the empty socket on the small circuitboard.5. Replace screw back into the small board and close case.MC145106 PLLThis PLL includes the following models.Browning Mark 4A, Dak Mark V,Robyn 440, Dak Mark IX, Lake 600, Palomar SSB500 (late), Regency CB501,SBE 54CB, Keycomm 1000Also these UNIDEN 'clones' use this chip.Connex 3300, Excalibur base,Excalibur Samurai, Galaxy 2100, Galaxy II, Galaxy Pluto, Galaxy Saturn,President Franklin, Superstar 3600, Superstar 3900, Super Galaxy, TexasStar.This PLL is getting used in a lot of newer radio's. It often has a pair ofMC14008 binary adders to extend the amount of channels available.The PLLuses 9 bit binary programming with internal pull-down resistors.Modifications are possible by changing the programming of pins 17(P0) topin 9(P8) or changing the mixing crystalPLL02AThe PLL02A is the worlds most popular chip used in all the Cybernetchassis. It is simple to modify by changing
Models include:- Uniden Grant/Madison, Cobra 148/2000 GTL etc. Note: Some newer Uniden's now have the RCI8719 'clone' Pll. You will have to replace the PLL with the old MB8719 BEFORE attempting these mods. To get coverage from 27.455 - 28.045, find the MB8719 PLL, then locate pins 10,11and 12. Cut the track going to these pins. Locate a ground .
10 - RNA Modifications After the RNA molecule is produced by transcription (Part 9), the structure of the RNA is often modified prior to being translated into a protein. These modifications to the RNA molecule are called RNA modifications or posttranscriptional modifications. Most RNA modifications apply onl
In the 26 years since 有iley publìshed Organic 1于ze Disconnection Approach 色y Stuart Warren，由自approach to the learning of synthesis has become while the book Ìtself is now dated in content and appearance' In 唱Tiley published Organic and Control by Paul Wyatt and Stuart 轧Tarren. Thís muc如柱。okís as a
regional planning process to develop all regional and local plan modifications, though regional planning processes are only required for the development of regional plan modifications as well as any local plan modifications that involve coordination of multiple Local Boards with a
Figure C1: Respiratory rate modifications made by site from ORC template 85 Figure C2: O 2 saturation modifications made by site from ORC template 86 Figure C3: O 2 flow rate modifications made by site from ORC template 86 Figure C4: Blood pressure modifications made by site from ORC template 87
Modifications to the Opinion in the Independent Auditor’s Report 971 AU-CSection705 Modifications to the Opinion in the Independent Auditor’s Report (SupersedesSASNo.122section705.) Source:SASNo.134;SASNo.137;SASNo.141. Effective for audits of financial statements for periods ending on or afterDecember15,2021. Introduction Scope of This .
Table ES.1 Motor vehicles covered by proposed modifications . 8 Table ES.2 Tariff schedules for imports of certain motor vehicles under KORUS. 9 Table ES.3 Probable economic effect of modifications to the staging of duty treatment: . Korean vehicle production and trade, 2013–17, number of vehicles . 24. Table 2.5 .
3. Proposed Modifications This section presents the analysis of the standard and the resulting proposed modifications, where each modif- ication is matched with the corresponding part in the current standard. It is also important to clarify that this article discusses only the
proposed modifications to the current average schedule formulas. All commenters state that the proposed modifications are both reasonable and meet the requirements of the Commission's rules.9 IV. DISCUSSION 5. Our analysis shows that all of the proposed formula changes, with
