BAT-X (Basic Asset Tracker, ATD500X) - Fccid.io
BAT-X(BASIC ASSET TRACKER, ATD500X)USER GUIDEV5.0.2
BAT-X1CONTENTS2Introduction . 33Firmware . 33.1456Firmware Versions . 3Quick Start . 34.1How to turn BAT-X on . 34.2LED Status Indicators . 3Operating Modes . 45.1Normal Mode . 45.2Discovery Mode . 55.3Factory Mode . 5Hardware . 66.1Sensors . 66.2Electrical . 66.3Miscellaneous . 66.4Radios . 77Contacts . 88Disclaimers . 89Version History. 95500 TRABUCCO ROAD SUITE 150, IRVINE, CALIFORNIA 92620P: 1 (949) 748-8895E: info@mobilogix.com MOBILOGIX, INC.
BAT-X2INTRODUCTIONThis document describes the Mobilogix BAT-X (Basic Asset Tracker, ATD500X). BAT-X is an asset tracker equipped with LTECatM1/NB1, quad-band 2G, Bluetooth, GNSS, environmental, and IMU sensors. The BAT-X may be in one of three operating modes.Factory mode is set on BAT-X during production for initial delivery and long-term storage of BAT-X. In Factory mode no radios are on,BAT-X waits for 10 minutes of charging to switch to Normal Mode. While in Normal mode, BAT-X will collect the asset location andsensor data and report the data to a cloud platform via cellular air interface. During Normal mode BAT-X may also collect peripheraldata via Bluetooth beacon scanning. After a report BAT-X will sleep until the next report (based on configured hold-off timers andthresholds). While not tracking any assets, or for short term storage, Discovery mode may be entered. Discovery mode shuts downall radios except Bluetooth until a wake-up command is received to push BAT-X into Normal mode.33.1FIRMWAREFIRMWARE VERSIONS 44.1BAT (Dam App): V5.0.2-officialBG96 (Cellular): BG96MAR02A10M1GBGM13P (Bluetooth): V502A3QUICK STARTHOW TO TURN BAT-X ONFrom the factory BAT-X must be connected to charger for 10 minutes to enter Normal Mode. Once BAT enters Discovery Modeit will send BT advertisements a unique name based on the cellular IMEI. To Switch BAT-X from Discovery Mode to Normal Modewrite 1 to the Cycling Power Vector.4.2LED STATUS INDICATORSData LEDSlow, short blinks:Slow, long blinks:Fast blinks:Trying to registerRegistered but idleData in transitPower LEDGreen:100% - 40%Yellow:39% - 20%Red:19% - 0%GNSS LEDBlinking:Acquiring locationSolid:Location acquired5500 TRABUCCO ROAD SUITE 150, IRVINE, CALIFORNIA 92620P: 1 (949) 748-8895E: info@mobilogix.com MOBILOGIX, INC.
BAT-X55.1OPERATING MODESNORMAL MODENormal Mode will allow BAT-X to go between sleeping and active work states to report data to the cloud. Active work statesare triggered by hold-off timers and threshold values according to the BAT-X configuration.Entry Triggers: Factory Mode to Normal Mode: Charge for 10 minutesDiscovery Mode to Normal Mode: Write operation via BluetoothExit Triggers: Normal Mode to Discovery Mode: REST APINormal Mode to Factory Mode: FOTAAvailable Functions: Normal Reporting:o Logino Location Datao Sensor Datao Beacon ReportAlarm Reporting:o Luxo Movemento Impact/DropConfigurationFOTARadio Modes: Cellular (BG96): Follows configured settings for wake/sleepBluetooth (BG13): Scanning for beacons5500 TRABUCCO ROAD SUITE 150, IRVINE, CALIFORNIA 92620P: 1 (949) 748-8895E: info@mobilogix.com MOBILOGIX, INC.
BAT-X5.2DISCOVERY MODEDiscovery Mode is an ultra-low-power mode where BAT-X acts as a Bluetooth beacon. Since no tracking is possible inDiscovery Mode it can be used to conserve battery during periods of inactivity.Entry Triggers: Normal Mode to Discovery Mode: REST APIExit Triggers: Discovery Mode to Normal Mode: Write operation via BluetoothAvailable Functions: BT OTABT AdvertisingRadio Modes: 5.3Cellular (BG96): OffBluetooth (BG13): Bluetooth advertisingFACTORY MODEBAT-X shall be configured in Factory Mode from factory production line. Factory Mode can be used for extended storage andlong (untracked) transport of BAT-X. The only exit trigger for Factory Mode requires physical access to BAT-X for charging.Entry Triggers: Normal Mode to Factory Mode: FOTAExit Triggers: Factory Mode to Normal Mode: Charge for 10 minutesAvailable Functions: No functions are available while in Factory Mode, all radios are off.Radio Modes: Cellular (BG96): OffBluetooth (BG13): Off5500 TRABUCCO ROAD SUITE 150, IRVINE, CALIFORNIA 92620P: 1 (949) 748-8895E: info@mobilogix.com MOBILOGIX, INC.
TemperatureCelsius ( C)-2060PressureHectopascals (hPa)3001100Humidity% Relative Humidity (%RH)0100LightLux (lx)064000Shock MagnitudeG Forces125.5Shock X-axisG Forces125.5Shock Y-axisG Forces125.5Shock Z-axisG Forces125.5Tilt X-axisDegrees0180Tilt Y-axisDegrees0180Tilt Z-axisDegrees0180ELECTRICALCapacity:Operating Voltage:Chemistry:Runtime:Charging:Max Charge Rate:6.34000 mAh 3.8 VLi-ion (rechargeable)Up to 1-year battery life on a single chargeMicro USB 2.0 (type B receptacle)1.2 AMISCELLANEOUSDimensions:Processor:SIM Card:23 x 122 x 60 (mm)ARM A73FF5500 TRABUCCO ROAD SUITE 150, IRVINE, CALIFORNIA 92620P: 1 (949) 748-8895E: info@mobilogix.com MOBILOGIX, INC.
BAT-X6.4RADIOSCellular Module:Bluetooth Module:Antenna:Quectel BG96 (Qualcomm MDM9206)Silabs BG13PEmbedded Cellular/GPS/Bluetooth/WiFi (rx)Radio Frequencies:LTE-FDD B1LTE-FDD B2LTE-FDD B3LTE-FDD B4LTE-FDD B5LTE-FDD B8LTE-FDD B12LTE-FDD B13LTE-FDD B18LTE-FDD B19LTE-FDD B20LTE-FDD B28LTE-TDD B39850 (B5)900 (B8)1800 (B3)1900 (B2)GPSBluetoothWiFiTX (MHz)1920 1850 1710 1710 824 880 699 777 815 830 832 703 2570 824.2 880.2 1710.2 1850.2 2400 14.81784.81909.82483.5-RX (MHz)2110 1930 1805 2110 869 925 729 746 860 875 791 758 2570 869.2 925.2 1805.2 1930.2 1575.4 2400 2400 59.81879.81989.81.0232483.52483.5Max Output Power:LTE-FDDLTE-TDD850 (B5) / 900 (B8)1800 (B3) / 1900 (B2)1800 (B3) / 1900 (B2) 8-PSK23 dBm23 dBm33 dBm30 dBm27 dBm 2 dB2 dB2 dB2 dB2 dB5500 TRABUCCO ROAD SUITE 150, IRVINE, CALIFORNIA 92620P: 1 (949) 748-8895E: info@mobilogix.com MOBILOGIX, INC.
BAT-X7CONTACTS tact/DISCLAIMERSFCC INTERFERENCE STATEMENT (PART 15.105 (B))This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipmentgenerates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may causeharmful interference to radio communications. However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turningthe equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or anexperienced radio/TV technician for help.8.2FCC PART 15 CLAUSE 15.21Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operatethe equipment.8.3FCC PART 15.19(A) [INTERFERENCE COMPLIANCE STATEMENT ], UNLESS THE FOLLOWING STATEMENT ISALREADY PROVIDED ON THE DEVICE LABELThis device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may notcause harmful interference, and (2) this device must accept any interference received, including interference that may causeundesired operation.5500 TRABUCCO ROAD SUITE 150, IRVINE, CALIFORNIA 92620P: 1 (949) 748-8895E: info@mobilogix.com MOBILOGIX, INC.
BAT-X8.4ISED RSS-GEN NOTICEThis device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:(1) This device may not cause interference; and(2) This device must accept any interference, including interference that may cause undesired operation of the device.Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation estautorisée aux deux conditions suivantes:(1) l’appareil ne doit pas produire de brouillage;(2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’encompromettre lefonctionnement.8.5FCC RF EXPOSURE GUIDANCE STATEMENTIn order to comply with FCC/ISED RF Exposure requirements, this device must be installed to provide at least 20 cm separation fromthe human body at all times.8.6ISED RF EXPOSURE GUIDANCE STATEMENTIn order to comply with FCC/ISED RF Exposure requirements, this device must be installed to provide at least 20 cm separation fromthe human body at all times.Afin de se conformer aux exigences d'exposition RF FCC / ISED, cet appareil doit être installé pour fournir au moins 20 cm deséparation du corps humain en tout temps.9VERSION HISTORYDateDescription2020-06-16Initial document version.2020-06-19Disclaimers included.5500 TRABUCCO ROAD SUITE 150, IRVINE, CALIFORNIA 92620P: 1 (949) 748-8895E: info@mobilogix.com MOBILOGIX, INC.
This document describes the Mobilogix BAT-X (Basic Asset Tracker, ATD500X). BAT-X is an asset tracker equipped with LTE CatM1/NB1, quad-band 2G, Bluetooth, GNSS, environmental, and IMU sensors. The BAT-X may be in one of three operating modes. Factory mode is set on BAT-X during production for initial delivery and long-term storage of BAT-X.
Global Asset Tracker Streaming Quick Start Guide 4 Unpack and power on Global Asset Tracker After unpacking the Global Asset Tracker, use the provided USB wall charger to plug it in to charge. The green Power LED will flash while the Sensor is charging, and will stay on when it is fully charged, which can take up to 4hours.
Frequently Asked Questions 1. What does the Minus mean? (Examples: -12, -8, -5). Always a minus number, it refers to the weight of the bat. Also referred to as the bat drop or the bat's length to weight ratio. Take the length of the bat and subtract the minus number and that is the weight. So a 33 inch bat that is -3 weighs 30 ounces.
Bat House Terms Bat house -This term is used interchangeably with "bat box". Baffles- Wood dividers between crevices within the bat house. Crevice-The interior space within the bat house where bats roost. Also referred to as "chamber". A 3/4" crevice size is ideal for both big brown and little brown bats. revice size should never be more than 7/8" or less than
Huntron Workstation software Tutorial for Tracker 2800/2800S It is very helpful if you have a working knowledge of Microsoft Windows prior to using . For this tutorial, the Tracker 2800 will be referred to in general as "Tracker". Select the Hardware tab and set the type of Tracker hardware to Tracker 2800, the
The Asset Tracker has an integrated ICM-20948 Inertial Measurement Unit for 9-Degree Of Freedom orientation and movement detection. Want to send a message if your asset is moved? The asset tracker can do that! It also. has a built-in digital microphone and so can send an alert as soon as a noise is detected too. Want to add a light
Unlike Townsend’s Big-eared Bat, Spotted Bat has black dorsal pelage with three white spots, and Pallid Bat is smaller with inconspicuous pararhinal glands 3. Distribution & Range: Townsend’s Big-eared Bat is widely distributed across the western half of North America from British Columbia to southern Mexico.
5.3.2. Text the tracker a SMS "APN123456 Space APN of your local GSM net operator" via a cell phone after obtaining your correct APN, and if succeeded in setup, the tracker will return the message "APN OK" e.g. send SMS command "apn123456 cmnet" to tracker device, If succeeded, "APN OK" is returned by the tracker in SMS.
3006 AGMA Toilet Additive 1338 (3006) 19.0% 2914 CERAVON BLUE V10 DC (2914) 0.05% 2922 FORMALDEHYDE REODORANT ALTERNATIVE (2922) 0.6% 3 Water (3) 80.05% Constituent Chemicals 1 Water (3) 80.05% CAS number: 7732-18-5 EC number: 231-791-2 Product number: — EU index number: — Physical hazards Not Classified Health hazards Not Classified Environmental hazards Not Classified 2 Bronopol (INN .
