DIGITAL AM/FM DUAL ALARM CLOCK RADIO

Alarm 1 is a ‘Sound Once’ alarm, and Alarm 2 is an ‘Everyday’ alarm. Alarm 1 Setting/Alarm 2 Setting Press the ‘Alarm 1’ button (Ref.4) or ‘Alarm 2’ button (Ref.5) to activate alarm settings. ‘OFF’ will begin lashing on the screen. Select Alarm 1 or 2 b

Run Card Requirements Continued Structure Fire goes to 7th Alarm and all 7 Alarm and all 7 Alarms are required. Brush Fire goes to 7th Alarm and all 7 Alarm and all 7 alarms are required. All other incident types can go to 4th Alarm Alarm and minimum of 2nd alarm is required.alarm is required. When a Compan

2. Open the alarm test valve. Verify that the sprinkler alarm bell and/or the pressure alarm switch/ electric alarm properly actuate. Close the alarm test valve and verify that water has ceased to flow from the alarm line drain. 3. Clean the 20 NB (3/4”) strainer provided on the sprinkler alarm bell line. 4. Clean the strainer of restriction .

Setting the Alarm 1. Press knob to turn ON alarm 2. Alarm time will begin to flash, adjust by rotating knob, press knob to select. (Alarm will automatically set to last selected alarm time after 6 seconds) 3. Press knob to turn OFF alarm In Single Day Alarm On Mode: alarm time will reset to 6:

DETECTION ZONE 11 DETECTION ZONE 12 ALARM ZONE 1 ALARM ZONE 2 ALARM ZONE 3 ALARM ZONE 4 Alarm Zones An alarm zone is clearly defined within the standard but generally is an area of the building coinciding with the fire compartment boundaries. There must be a clear break between these alarm zones to ensure alert and evacuation messages are not .

How Alarms Fit into Process Operating Situation 6 Alarm Management 8 Benefi ts 8 imo-rothenberg-00fm.indd ix 7/31/09 1:07 PM. x Contents † Chapter 1 1.4 A Brief History of Alarm Management 10 1.5 The “Management” in Alarm Management 11 1.6 Alarm Design Roadmap 12 1.7 Audience for this Book 13 1.8 Importance of Alarm Management 13 1.9 Fundamentals of Alarm Management 15 Bottom Line of .

Smoke alarm does not respond. Please check whether the alarm is activation Red LED flashes and the alarm sounds one beep every 60 seconds. Battery is low. Please deactivate the alarm and replace immediately! Red LED flashes and the alarm sounds two beeps e every 50 seconds. The alarm is malfunctioning. Please deactivate the alarm and replace

national fire alarm code, and section 13.7. 2006 nf pa 1. fire alarm system installation and maintenance shal l be in accordance with nfpa 72, national fire alarm code, and 2006 nfpa 1. 13.7.1.4.9.8 audibility. the alarm signal shall be a distinctive sound, which is not used for any other purpose other than the fire alarm. alarm-signaling