Peterbilt 337 And 382 Standard Install Guide PeopleNet Mobile Gateway .

Peterbilt 379-384-385-386-387-388-389 PeopleNet Mobile Gateway (PMG) Install Guide

Hardware Overview Display Display Cable Power Assembly PMG Antenna Auxiliary Cable 2-Pin Main Cable

Non-PeopleNet Parts Needed Peterbilt provides secure spare connections for Power-IgnitionGround, but these connections require a mating adapter. This adapter is available from a number of sources, with Peterbilt the cheapest at around 10. – – Peterbilt Part #16-09171 Two are required per install, one for constant power and one for ignition sense. If no adapter is available, you can connect with a standard blade but be sure it is well secured against vibration or accidental removal.

Install Overview PMG Power Connections Antenna Display Option 1 Engine Data Fuse Panel Display Option 2

Power Connections Splice the Constant Power (red) and Ground (black) to one locking power plug and the Ignition Sense (white) to the red of the other. Connect Connect the the Ignition Ignition Sense Sense plug plug toto anan open spare open spare port on port theon forward the forward (Switched (Switched Power) row, Power) selecting row, selecting one of the oneright of the 3 toright avoid 3 to the avoid Low the Low Voltage Voltage Disconnect Disconnect circuit. circuit. Connect Connectthe theConstant ConstantPower Powerplug plugtotoan an open open spare spare portport on on thethe rearrear (Battery (Battery Power) row, Power) selecting row, selecting one of the oneright of the 3 toright avoid 3 to the avoid Low the Low Voltage Voltage Disconnect Disconnect circuit. circuit.

Fusing Fuse the positions corresponding to the Constant and Ignition power. 10 amps for Constant Power 5 amps for Ignition Sense

J1939 Engine Data – All Vehicles Locate the J1939 backbone black/blue connector with yellow/green wires behind the ignition switch. Click here for a video of this process. Connect the PMG 2-pin using the two “PACCAR” pigtails from the 2-pin kit. If the vehicle connector comes apart showing 4 pins and a resistor, remove that piece from the black 2-pin and reinsert it in the blue female connector.

J1708 Engine Data – Pre-2010 Model Years If the vehicle was built before model year 2010, connect the black 2-pin J1708 to the block behind the ignition switch. If the vehicle is 2010 or newer, this connection is not needed.

Antenna Secure the antenna on top of all center-dash wiring and modules using the tape provided and a zip-tie. NOTE: If no secure mount is available, move the antenna to the top of the airducts above the glove-box.

Display Mount Option 1 If central dash space is available, attach the RAM mount using bolts and large washers or a backing plate.

Display Mount Option 2 If the dash provides no mount space, attach the RAM mount to the passenger’s side using bolts and large washers or a backing plate. Route the cable into the dash below the glovebox being sure the cable isn’t pinched.

PMG Mount Bundle any extra cabling in the open central dash space. Mount the PMG to the back of the central airduct using 2-sided tape and a zip-tie or screw.

Non-PeopleNet Parts Needed Peterbilt provides secure spare connections for Power-Ignition-Ground, but these connections require a mating adapter. This adapter is available from a number of sources, with Peterbilt the cheapest at around 10. - Peterbilt Part #16-09171